LCOS controls relays through DNOU8 digital output ports. When installing relays on your layout, keep track of the DNOU8 ports you use; you’ll need that information to configure the relays in LCOS.
Important: For information about relay types supported and how to wire them, see Relays.
The Relay Tool
On the Main Window, click to invoke the Relay Tool.
The Relay Tool is divided into three zones: add, edit and list.
To ADD a new relay, select a New Relay Type, then select the port(s) the relay is attached to. With the compound relays, port 1 should lead to the power control relay, and port 2 should lead to the input or output selector.
After setting one or two ports (depending on relay type), click to add the new relay to the list.
Remember to save the configuration to the Node by clicking .
To complete the change, the node must rebooted. On the Main Window, click to reboot and load the new configuration.
Test the Relay
In the edit zone of the Relay Tool, select the relay object from the drop-list. Click to briefly cycle the relay and see it operate. Relay tests are direct and do not involve the layout loop. Accordingly, you do not have to put the node in Normal mode in order to do the relay test.